Diagnosing With The Leds - ProCurve Wireless Access Point 10ag Installation And Configuration Manual

Diagnosing with the LEDs

Table 6-1 shows LED patterns on the access point that indicate problem
conditions.
1. Check in the table for the LED pattern that you see on your access point.
2. Refer to the corresponding diagnostic tip on the next few pages.
Table 6-1. LED Error Indicators
LED Pattern Indicating Problems
Power LED
Off with power cord plugged in
Off without power cord plugged in,
but linked to a PoE source
Prolonged on or off during
†
initialization
On
On
On
* This LED is not important for the diagnosis.
†
Initialization takes between 30 seconds and one minute after a power on or reset.
Radio LEDs
*
*
Prolonged on or off Prolonged on or off
during during initialization
†
initialization
Off
* Off with cable
* On, but the port is not
communicating
Troubleshooting
Diagnosing with the LEDs
Diagnostic
LAN LED
Tips
*
1
* 2
3
†
* 4
5
connected
6
6-3