Step 3. Verify The Access Point Completes Initialization - ProCurve Wireless Access Point 10ag Installation And Configuration Manual

Connect the power adapter to
the power connector
N o t e

Step 3. Verify the Access Point Completes Initialization

Before deploying the access point to its network location, you should first
verify that it is working properly by plugging in the AC adapter, or connecting
it to a switch that provides Power over Ethernet, and verifying that it
completes its system initialization.
1. Connect a network cable from a PoE source device (such as a switch) to
the RJ-45 port on the back of the access point, or connect the supplied
power adapter to the power connector on the back of the access point,
and then into a properly grounded electrical outlet.
The Access Point 10ag does not have a power switch. It is powered on when
the power adapter is connected to the access point and to a power source, or
when a network cable is connected to the access point and to a network device
that provides Power over Ethernet.
For safety, when connecting to an electrical outlet, the power outlet should
be located near the access point.
Use only the AC power adapter supplied with the access point. Use of other
adapters, including adapters that came with other ProCurve Networking
products, may result in damage to the equipment.
Or connect a network
cable to a PoE switch
Installing the Access Point
Installation Procedures
2-9