Step 6. Connect The Network Cable; Using The Rj-45 Connectors - ProCurve Wireless Access Point 10ag Installation And Configuration Manual

Installing the Access Point
Installation Procedures
2-12

Step 6. Connect the Network Cable

Connect the network cable, described under
page 2-7, from the network device or your patch panel to the LAN port on the
access point.

Using the RJ-45 Connectors

To connect:
Push the RJ-45 plug into the LAN port
until the tab on the plug clicks into
place. When power is on, one of the
two LAN LEDs should turn on to
confirm a valid network connection.
If neither LAN LED turns on, see
"Diagnosing with the LEDs"
Chapter 5.
Congratulations! You have
completed installing your access
point. You are now ready to start
configuring your access point
settings.
Please continue to Chapter
"Getting Started With Access Point Configuration"
Web interface and a summary of essential configuration tasks that you should
perform.
""Cabling Infrastructure"
in
Category 5 cable for 10/100 Mbps ports (UTP)
Maximum distance: 100 meters
3,
on
RJ-45
connector
for an introduction of the