Restoring A Switch; Restore Dialogs - Full Restore And Selective Restore Tab Pages - HP SAN Switch User Manual

Restoring a switch

Restoring a switch loads the archived switch configuration parameters to the switch. The switch
configuration must be archived before it can be restored. The switch archive must be compatible with the
switch to be restored; that is, you can restore a McDATA switch only with an archive from a McDATA Web
Server switch. See
CAUTION:
The switch being restored should be physically disconnected from the fabric. Restoring a
switch in a fabric can severely disrupt the fabric. After the restore process is complete, the switch can be
reconnected to the fabric.
The Restore dialog consists of the Full Restore tab page and Selective Restore tab page. To restore a
switch:
1.
Log in to the fabric through the switch you want to restore. You cannot restore a switch over an ISL.
2. Select Switch > Restore in the faceplate display to open the Restore dialog shown in
Figure 35
Restore Dialogs – Full Restore and Selective Restore tab pages
3.
Enter the archive file name or browse for the file. This archive file must be one that was produced by the
Archive function. Configuration backup files created with the Config Backup command are not
compatible with the McDATA Web Server Restore or Element Manager Restore function.
"Archiving a switch" on page 78 for more information.
McDATA® 4Gb SAN Switch for HP p-Class BladeSystem user guide
Figure 35.
79