Managing The Zoning Database; Editing The Zoning Database; Edit Zoning Dialog - HP SAN Switch User Manual

4gb san switch for p-class bladesystem
Table of Contents

Advertisement

Managing the zoning database

Managing the zoning database consists of the following:
• Editing the zoning
• Configuring the zoning
• Saving the zoning database to a
• Restoring the zoning database from a
• Restoring the default zoning
• Removing all zoning

Editing the zoning database

To edit the zoning database for a particular switch, open the Zoning menu and select Edit Zoning to open
the Edit Zoning dialog shown in
stored in flash (non-volatile) memory and retained after resetting a switch.
Figure 14

Edit zoning dialog

To apply zoning to a fabric, choose a zone set and activate it. When you activate a zone set, the switch
distributes that zone set and its zones to every switch in the fabric. This zone set is known as the active
zone set.
You cannot edit an active zone set on a switch. You must configure an inactive zone set to your needs and
then activate that updated zone set to apply the changes to the fabric. When you activate a zone set, the
switch distributes that zone set to the temporary zoning database on every switch in the fabric. However, in
addition to the merged active zone set, each switch maintains its own original zone set in its zoning
database.
NOTE:
If the Interop Auto Save parameter is enabled on the Zoning Configuration dialog, then every time
the active zone set changes, the switch will copy it into an inactive zone set stored on the switch. You can
edit this copy of the active zone set stored on the switch, and activate the updated copy to conveniently
apply the changes to the active zone set. The edited copy then becomes the active zone set.
The Edit Zoning dialog has a Zone Sets tree on the left and a Port/Device (or members) tree on the right.
Both trees use display conventions similar to the fabric tree for expanding and contracting zone sets,
zones, and ports. An expanded port shows the port Fibre Channel address; an expanded address shows
the port World Wide Name. You can select zone sets, zones, and ports in the following ways:
40
database, page 40
database, page 42
file, page 42
file, page 42
database, page 43
definitions, page 43
Figure
14. Changes can only be made to an inactive zone set, that is
Zone Sets
Tree
Port/Device
Tree

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mcdata

Table of Contents