HP SAN Switch User Manual page 63

Table 8
Switch data window entries (Continued)
Entry
SNMP Enabled
Zones/Security
Interop Mode
Legacy Address Format
Interop Auto Save
Security Auto Save
Security Fabric Binding Enable
Zoning Default Visibility
Default Zone
Discard Inactive
Implicit Hard Zoning
Advanced
R_A_TOV
E_D_TOV
Number of Donor Groups
Inactivity Timeout
Interop Mode
Legacy Address Format
In-band Enabled
Principal Switch
239 Domain Support
Description
SNMP enabled or disabled.
Interoperability mode. Use Standard to connect to FC-SW-2
compliant switches and McDATA switches in Open Fabric Mode. Use
McDATA Fabric Mode to connect to McDATA switches in McDATA
Fabric Mode. The default is Standard.
Not applicable.
Zoning auto save status. Saves zoning updates in temporary memory
and the zoning database (True) or only in temporary memory (False).
Enable to automatically save security settings to permanent memory
on the switch.
If enabled, the expected domain ID of a switch is required before
attaching to the fabric.
Not applicable.
Disables communication between ports and devices not defined in
the active zone set, or when there is no active zone set.
Automatically removes the previously active zone set when a zone set
is activated on a switch.
Introduces hardware enforcement of zoning regardless of type. All
zones and all supported zone member types will have hardware
enforcement.
Resource allocation timeout value
Error detect timeout value
Total number of donor port groups. A donor group is a set of ports
on a switch that can donate buffer credits to each other.
Number of minutes the switch waits before terminating an idle
command line interface session. Zero (0) disables the time out
threshold.
Interoperability mode. Use Standard to connect to FC-SW-2
compliant switches and McDATA switches in Open Fabric Mode. Use
McDATA Fabric Mode to connect to McDATA switches in McDATA
Fabric Mode. The default is Standard.
Not applicable.
In-band management status. Permits (True) or prevents (False) a
switch from being managed over an ISL.
If there is a domain ID conflict in the fabric, the switch with the
highest principal priority, or the principal switch, will reassign any
domain ID conflicts and establish the fabric.
239 domain support status. When enabled on every switch in the
fabric, valid domain IDs are expanded to 1–239.
McDATA® 4Gb SAN Switch for HP p-Class BladeSystem user guide 63