Table of Contents
Advertisement
OPERATING PROCEDURE
Turn temperature control knob from "off" position to the desired temperature. This will automatically
heat the griddle to the temperature the control knob is set. The thermostat will shut off automatically
when the desired temperature is reached, and the pilot light will remain on until until the unit is turned
off. The griddle is to be kept at this setting for immediate service and left at this setting as griddle
will remain at constant temperature. If it is turned off, you will have to wait 0 to 20 minutes for it to
reheat. If griddle is too hot, turn knob to lower temperature.
Turn off when leaving at night.
TG2 Models have separate left & right controls and can be operated independently.
PILOT LIGHT
Pilot light will go on when the unit is first turned "ON" and will remain "ON" until the unit is turned off.
DAILY SEASONING
The grill should not require much seasoning while in use. In most cases, brushing a light coating
of the baking release agent in the morning and occasionally throughout the day will be enough to
prevent any sticking. It is not necessary to spray before grilling each item.
CLEANING
Use only cleaners which are safe for ALUMINUM. DO NOT use caustic cleaners, ice or cold water to
clean the grill. Turn grill down or OFF during idle periods to prevent carbon buildup.
. Turn power off and unplug, allow grill to cool.
2. Remove particles by using a spatula with rounded corners.
. Wipe down all surfaces using a warm damp cloth and mild detergent.
CARBON CLEANING
When carbon buildup occurs, use a carbon removal agent which is safe for aluminum, follow the
instructions provided with the product. When this process is complete, you must re-season your grill.
OPERATING HINTS AND SAFETY
Disconnect power to the unit with the switch at the end of each day of operation.
Do not leave the unit in operation unattended.
Turn thermostat down during idle periods. It will take only a few minutes to regain operating
temperature.
Do not leave the unit at a high temperature when not in use or during idle periods. This will cause
food particles and grease film to carbonize
DO NOT IMMERSE OR LET THE UNIT STAND IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE TABLE/COUNTER IF THE UNIT IS ON THE
WARNING
TABLE/COUNTER.
KEEP AWAY FROM RUNNING WATER.
DO NOT USE SHARP OBJECTS TO REMOVE CARBON BUILD-UP.
BEFORE CLEANING MAKE SURE POWER IS TURNED OFF, UNIT IS UNPLUGGED AND IS
NOT TOO HOT.
CAUTION
DO NOT CLEAN SURFACE WITH ICE.
Apply only cleaners which are safe for aluminum and iron surfaces. Wipe with clean
sponge or towel until unit is clean.
MAINTENANCE AND REPAIRS
Disconnect the unit from the power source before installing or removing any parts. Contact the
factory or an authorized service representative for service or required maintenance.
5
Advertisement
Table of Contents
