Operating Instructions - Pro-Max CG14SPT Installation And Operation Instructions Manual

Split lid table top two sided grill
Table of Contents

Advertisement

OPERATING INSTRUCTIONS

. Turn unit on by placing switch in "ON" position. The "Heat On" indicator, program number and
display will flash indicating unit is heating. When the preset temperature is reached, the heating
light, display and program light indicator will stop flashing followed by 3 beeps. (Initial startup
heating time is approximately 0 minutes).
. Place product on the bottom cooking surface of the unit and close the lids.
. Press program button and let displayed time count down to "0" at which time unit will beep.
To turn off the beeper, press program button again.
4. Raise lids until it engages into first indent and remove food. Using spatula, scrape residue into
grease catcher tray.
Note: Metal utensils with rounded corners may be used, however, using nonmetal utensils will
prolong the life of the cooking surface.
5. Turn the unit off when not in use.
TEMPERATURE/TIMER CONTROLLER OPERATION SPECIFICATIONS
Startup:
1. The preset time will flash until preset temperature is reached.
. When the control reaches preset temperature, time display, "Heat On" indicator and program
indicator will stop flashing and the alarm will beep three times.
Temperature:
. To view the actual temperature, press and hold "Temp Button." Display will read "Lo F" if temperature
is below 7°F (°C) and "Hi F" if temperature is above 57°F (0°C).
To Program Time and Temperature:
. Press and hold "TEMP" (actual temperature displays).
. While holding "TEMP," press and hold any program button on the Left one second, the LED
above the program number light and the display reads "_ _ _ _." Enter the four-digit security code
sequence, , , , . The security code will not show on the display. Once the correct sequence
has been entered, the preset time will be displayed and the LED for that program will begin to
flash.
. Set the time with the "+ or -" buttons.
. Press the "TEMP" button to save the time.
5. The preset temperature will now be displayed.
6. Set the desired temperature for this program using the "+ or -" buttons.
7. Press the "TEMP" button to save temperature and to exit programming mode for this program.
The LED will stop flashing but will remain lit.
8. Press any other program button within 5 seconds to continue programming without re-entering
the security code.
9. While programming a program (LED is flashing), if no input is received for 15 seconds, the unit
will revert to normal operation and the security code must be re-entered.
Note: Temperature settings are done with the left side buttons only. The time settings
programmed on the Left buttons will also be programmed onto the right side. See below to make
time changes to the right side only. Each programming change must be saved by pressing the
"TEMP" button!
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents