Operating Procedure; Maintenance And Repairs - Pro-Max TG1 Installation And Operation Instructions Manual

OPERATING PROCEDURE

Turn temperature control knob from "off" position to the desired temperature. This will
automatically heat the griddle to the temperature the control knob is set. The thermostat will
shut off automatically and the pilot light will go out when the temperature is reached. The
griddle is to be kept at this setting for immediate service and left at this setting as griddle will
remain at constant temperature. If it is turned off, you will have to wait 10 to 20 minutes for
it to reheat. If griddle is too hot, turn knob to lower temperature.
Turn off when leaving at night.
TG2 Models have separate left & right controls and can be operated independently.
PILOT LIGHT
Pilot light will go on when the unit is fi rst turned on or when control knob is turned to higher
temperature. It will go off when temperature is reached.
DAILY SEASONING
The grill should not require much seasoning while in use. In most cases, brushing a light coating
of the baking release agent in the morning and occasionally throughout the day will be enough
to prevent any sticking. It is not necessary to spray before grilling each item.
CLEANING
Use only cleaners which are safe for ALUMINUM. DO NOT use caustic cleaners, ice or cold
water to clean the grill. Turn grill down or OFF during idle periods to prevent carbon buildup.
1. Turn power off and unplug, allow grill to cool.
2. Remove particles by using a spatula with rounded corners.
3. Wipe down all surfaces using a warm damp cloth and mild detergent.
CARBON CLEANING
When carbon buildup occurs, use a carbon removal agent which is safe for aluminum, follow
the instructions provided with the product. When this process is complete, you must re-season
your grill.
OPERATING HINTS AND SAFETY
Disconnect power to the unit with the switch at the end of each day of operation.
Do not leave the unit in operation unattended.
Turn thermostat down during idle periods. It will take only a few minutes to regain operating
temperature.
Do not leave the unit at a high temperature when not in use or during idle periods. This will
cause food particles and grease fi lm to carbonize
DO NOT IMMERSE OR LET THE UNIT STAND IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE TABLE/COUNTER IF THE UNIT IS ON THE
TABLE/COUNTER.
WARNING
KEEP AWAY FROM RUNNING WATER.
DO NOT USE SHARP OBJECTS TO REMOVE CARBON BUILD-UP.
BEFORE CLEANING MAKE SURE POWER IS TURNED OFF, UNIT IS UNPLUGGED AND
IS NOT TOO HOT.
CAUTION
DO NOT CLEAN SURFACE WITH ICE.
Apply only cleaners which are safe for aluminum and iron surfaces. Wipe with clean
sponge or towel until unit is clean.

MAINTENANCE AND REPAIRS

Disconnect the unit from the power source before installing or removing any parts. Contact
the factory or an authorized service representative for service or required maintenance.
5