Figure C-8. Rear View Of The Fibre Channel To Scsi Router; Table C-2. Fiber Cables - HP 9840 Operation Manual

Installing and Configuring the Tape Drive for the
NonStop NS-Series Server
The fiber cable is a multimode/short wave fiber optic cable. This cable is normally
an orange color.

Table C-2. Fiber Cables

Connector
LC - LC
LC - LC
11. Power on the 9840 tape drive. See
wait for it to perform its power-on-self-test (POST).
12. Power on the router, and then wait for it to perform its power-on-self-test (POST).
Configuration
1. In SCF, issue this command:
SCF> ADD TAPE $tape, SENDTO STORAGE, LOCATION (group, module,
slot), SAC sac-id, PORTNAME 64-bit-portname, LUN lun-id
Example:
SCF> ADD TAPE $TAPE1, SENDTO STORAGE, LOCATION (110,2,3), SAC
1, PORTNAME 100000E00C00F000,LUN 1
Note. The LUN in SCF should be 1 for the tape drive that is on bus 0. The LUN in SCF should
be 3 for the tape drive that is on bus 1.
Note. PORTNAME in SCF corresponds to the WWP name of the router. This name is located
on the back of the device.

Figure C-8. Rear View of the Fibre Channel to SCSI Router

Fiber Cable
50/125 µm
62.5/125 µm
WWNN: 100000E00200F000
WWPN: 100000E00C00F000
ENET MAC ID: 00:E0:02:00:00:XY
9840 Tape Drive Operations Guide— 429596-002
Fiber Cable Distance
2-300 meters (6.56-984.25 feet)
3-150 meters (9.84-492.13 feet)
Figure C-6 for the power switch location. Then
C- 8
Configuration
WWN Name
WWP Name
Ethernet MAC ID
(Physical Address)