HP P4459A Installation & Operation Manual page 36

HP P4459A 8-Port Fibre Loop Switch Installation & Operation Guide
Plugging in the other end of the power cord will apply power to the switch.
You can do either of the following:
• Connect the other end of the power cord to the power receptacle on
• Wait to plug in the other end of the power cord, so that you can con-
2. If you purchased a filler panel separately, install the filler panel on the
front of the rack by pressing it into place, as shown in Figure 16.
Figure 16: Installing the Filler Panel (Shown for HP Rack System/E and HP Rack
System/U Racks)
Filler Panel
Left Front Rack Column
3. Retract the anti-tip foot, if desired.
28
the rack, which means you will hot-plug devices to the switch.
nect devices to the switch before you power it.
Right Front Rack Column
Left Rear Rack Column
Right Rear Rack Column
Switch