Figure 6: Mounting in HP Rack System/E and HP Rack System/U Racks
Left Front
Rack Column
"R" Spacer
Tools Required
To install the switch in an HP rack, you need a T25 Torx driver and a #1 Phillips-
head screwdriver.
HP Rack Mounting Installation Steps
Installing the fibre loop switch into an HP rack requires the following general
steps:
•
Step 1: Preparation
•
Step 2: Mark the Rack Column Holes
•
Step 3: Place the Barrel Nuts on the Rack Columns
• Also install the "L" and "R" spacers on the front columns of HP Rack
Right Front Rack Column
"L" Spacer
Left Rear Rack Column
System/E and HP Rack System/U racks only.
Right Rear Rack Column
Sleeves
Installing the Fibre Loop Switch
Switch
Rails
15