Table of Contents
Advertisement
Module Installation
C a u ti o n — R o u ti n g S w it c h 9 3 0 4 M a n d 9 30 8 M
To avoid hardware damage during module installation, be careful to properly line up the edges of the module
board with the guides built into the module slot on the chassis.
Getting Started
You can initially access the routing switch in either of the following ways:
Via Telnet or FTP through port 1 on the management module, using the factory default IP address (209.157.22.254)
and subnet mask (255.255.255.0)
By connecting a terminal device to the serial port on the management module
Note: HP recommends that you use the console cable provided with the routing switch. If you need to use a different
cable, please see the "Console Cable" entry under "Accessory Parts List" on the next page.
After you have accessed the routing switch, change the default IP address and subnet mask to correspond to your network's
addressing scheme. For more on assigning an IP address and other topics, see the following:
Topic
Installation Procedures and Precautions
Attaching a Terminal Device and Assigning an IP
Address
Using Redundant Management Modules
System Boot from a Bootp Server
Software Overview
Hardware Overview and Specifications
Enabling Telnet
Your Free Ticket to Proactive Networking!
HP TopTools for Switches & Hubs is a breakthrough in network management software that gives you more network with
less work. The TopTools for Switches & Hubs CD is included at no extra charge with your HP ProCurve routing switch. See
the system requirements printed on the sleeve containing the HP TopTools CD.
2
Location in the Installation
and Configuration Guide
Chapter 2
Chapter 2
Chapter 3
Appendix B
Chapter 5
Chapter 6
Chapters 2 (pp. 2-28, 2-29) and 5 (p. 5-9)
Advertisement
Table of Contents
