Installation Of Type I Dome Camera - HIKVISION DS-2CD4312 Quick Operation Manual

Network Dome Camera· Quick Operation Guide
● Make sure that there is no reflective surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing reflection.
● The foam ring around the lens must be seated flush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are attached seamlessly.
2.1

Installation of Type I Dome Camera

Steps:
1. Drill the screw holes and the cable hole according to the supplied
drill template.
2. Install the mounting base to the ceiling with the supplied screws.
Drill Tempalte
4
2 1
3
Screw Hole 3: for
Mounting Base
3
2 1
4
Figure 2-1 Drill Template
12
4
2
3
Hole A: for cables routed
through the ceiling
3
2
4
Code: 190600839