Power Converter Module - HP ProLiant BL20p Generation 3 Maintenance And Service Manual

Removal and Replacement Procedures
8. Grasp the SCSI backplane on the left side when facing the rear of the server blade and lift
slightly to rotate the SCSI backplane out (1).
9. Lift the SCSI backplane out of the chassis (2).
Figure 2-20: Removing the SCSI backplane
To replace the component, reverse the removal procedure.

Power Converter Module

To remove the power converter module:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blade Preparation" section in this chapter.
2. Remove the access panel. Refer to "Access Panel" in this chapter.
2-22 HP ProLiant BL20p Generation 3 Server Blade Maintenance and Service Guide