HP ProLiant BL20p Generation 3 Maintenance And Service Manual page 36

4. With a T-6 Torx screwdriver, remove the two retaining screws from the bottom of the
chassis (1).
5. Disconnect the power button/LED cable from the back left side of the power button/LED
board.
6. Slide the power button/LED board toward the left outside edge of the chassis (2).
Figure 2-23: Removing the power button/LED retaining screws
7. Tilt the front edge of the power button/LED board down until the keyholes on the rear of
the board clear the alignment pins (1).
8. Slide the power button/LED board out of the front of the chassis (2).
Figure 2-24: Removing the power button/LED board
HP ProLiant BL20p Generation 3 Server Blade Maintenance and Service Guide
Removal and Replacement Procedures
2-25