Troubleshooting Guide - Kenwood FP970 series Instructions Manual

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection centre or
to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative
consequences for the environment and health deriving from inappropriate
disposal and enables the constituent materials to be recovered to obtain
significant savings in energy and resources. As a reminder of the need to
dispose of household appliances separately, the product is marked with a
crossed-out wheeled dustbin.

troubleshooting guide

Problem
The processor will not operate
Processor stops or slows
during processing
Poor performance of
tools/attachments.
Power On light flashing
Auto and Power On light
flashing
Cause
No power - power on light not lit.
Bowl not locked on correctly.
Lid not locked correctly.
Large pusher not fitted.
Overload protection operated.
Processor overloaded or overheated during
operation.
Maximum capacity exceeded.
Refer to hints in relevant "using the attachment" section. Check attachments are assembled correctly.
Normal operation
The light will flash if the bowl, lid, liquidiser or
mill are not fitted to the power unit or not locked in
place correctly.
Normal operation
The light will flash if the
Auto selected but interlocks not engaged.
Solution
Check processor is plugged in.
Check bowl is located and interlocked correctly and the handle is situated
towards the right hand side.
Check that the lid interlock is located correctly into the handle area.
Fit the large pusher.
The processor will not operate if the bowl, lid or large pusher
are not interlocked correctly.
If none of the above check the fuse/circuit breaker in
your home.
Switch off, unplug and allow the appliance to cool down for approximately
15 minutes.
Refer to the speed chart for maximum capacities to process.
Check interlocks are engaged correctly.
Check interlocks are engaged correctly or press the Auto button to switch
off the Auto function.
7