Table of Contents
Advertisement
Installing or Replacing Server Components
h.
Special Considerations for Cisco UCS Virtual Interface Cards
Table 3-8
Table 3-8
Cisco UCS C22 Requirements for Virtual Interface Cards
Number of
VICs
Virtual Interface Card
Supported
(VIC)
in Server
2
Cisco UCS VIC P81E
N2XX-ACPCI01
Cisco UCS VIC 1225
UCSC-PCIE-CSC-02
Cisco UCS VIC1225T
UCSC-PCIE-C10T-02
Cisco UCS VIC1285
UCSC-PCIE-C40Q-02
1. See
PCIe Slots, page
3-34.
2. See note below.
3. The Cisco UCS VIC1225T is not supported for UCS integration at this time.
The Cisco UCS VIC P81E is not supported in the C22 Large Form Factor version of the server.
Note
RAID Controller Card Cable Routing
If the PCIe card that you are installing or replacing is a RAID controller card, see
Considerations, page C-1
See also
installing a RAID backup unit for a RAID controller card.
Cisco UCS C22 Server Installation and Service Guide
3-36
If the card that you replaced was a RAID controller, continue with
After Replacing a RAID Controller, page
describes the requirements for the supported Cisco UCS virtual interface cards (VICs).
Slots That
Support
1
VICs
1
PCIE 1
1
PCIE 1
1
PCIE 1
1
PCIE 1
for required cables and cable routing guidelines.
Replacing the SuperCap Power Module (RAID Backup Unit), page 3-41
C-22.
Primary Slot For
UCS Integration
Minimum
or Cisco Card
Cisco IMC
NIC Mode
Firmware
PCIE 1
1.4(5)
PCIE 1
1.4(6)
3
PCIE 1
1.5(1)
PCIE 1
1.5(4)
Chapter 3
Maintaining the Server
Restoring RAID Configuration
Minimum VIC
Minimum Nexus
Firmware For
OS on an Upstream
Use With UCS
Nexus Fabric
Integration
Interconnect
2.0(2)
5.0
2.1(0)
5.0
2.1(1)
5.0
2.2(1b)
5.0
RAID Controller
for instructions on
OL-26646-01
Advertisement
Table of Contents
