Special Considerations For Cisco Ucs Virtual Interface Cards; Raid Controller Card Cable Routing - Cisco UCS C24 Installation And Service Manual

Chapter 3 Maintaining the Server
e.
f.
g.
h.
i.

Special Considerations for Cisco UCS Virtual Interface Cards

Table 3-6
Table 3-6 Cisco UCS C24 Requirements for Virtual Interface Cards
Number of
VICs
Virtual Interface Supported
Card (VIC) in Server
Cisco UCS VIC P81E
N2XX-ACPCI01
Cisco UCS VIC 1225
UCSC-PCIE-CSC-02
1. See PCIe Slots, page 3-31.

RAID Controller Card Cable Routing

If the PCIe card that you are installing or replacing is a RAID controller card, see
Considerations, page C-1
See also
installing a RAID backup unit for a RAID controller card.
OL-26647-01z
Carefully push down on both ends of the PCIe riser to fully engage its circuit board connector with
the socket on the motherboard.
Connect cables to the PCIe card. See
information about supported cards and cabling.
Replace the top cover.
Replace the server in the rack, replace cables, and then power on the server by pressing the Power
button.
If you replaced a RAID controller card, continue with
Replacing a RAID Controller, page
describes the requirements for the supported Cisco UCS virtual interface cards (VICs).
Slots That
Support
1
VICs
2 PCIE 1
PCIE 2
2 PCIE 1
PCIE 2
for cable routing and other guidelines.
Replacing a SuperCap Power Module (RAID Backup Unit), page 3-34
RAID Controller Considerations, page C-1
C-6.
Primary Slot For
UCS Integration Minimum
or Cisco Card CIMC
NIC Mode Firmware
PCIE 1 1.4(5)
PCIE 1 1.4(6)
Cisco UCS C24 Server Installation and Service Guide
Installing or Replacing Server Components
Restoring RAID Configuration After
Minimum VIC Minimum Nexus
Firmware For OS on an Upstream
Use With UCS Nexus Fabric
Integration Interconnect
2.0(2) 5.0
2.1(0) 5.0
RAID Controller
for instructions on
for more
3-33