Replacing A Scu Upgrade Rom Module - Cisco C22 Installation And Service Manual

Installing or Replacing Server Components

Replacing a SCU Upgrade ROM Module

To remove and replace a module, use the following procedure.
Prepare the server for component installation:
Step 1
a.
b.
If you cannot safely view and access the component, remove the server from the rack.
Caution
c.
Remove the SCU upgrade ROM module:
Step 2
a.
b.
Install a new SCU upgrade ROM module:
Step 3
a.
b.
Figure 3-25
1
2
For more information about using the module and embedded RAID, see
page
Cisco UCS C22 Server Installation and Service Guide
3-46
Power off the server as described in
Slide the server out the front of the rack far enough so that you can remove the top cover. You might
have to detach cables from the rear panel to provide clearance.
Remove the top cover as described in
Locate the module on the motherboard (see
Grasp the printed circuit board of the module and lift it from the header.
The module has a small retention feature that must have clearance from the header before
Note
the module can be pulled up. Tilt the module back, then pull up as shown in
Align the module with the pins in the motherboard header.
Gently press down on the module until it is seated and the retention feature locks into the header.
SCU Upgrade ROM Module Retention Feature
1
2
3
Printed circuit board on module
Retention feature on module
C-5.
Shutting Down and Powering Off the Server, page
Removing and Replacing the Server Top Cover, page
Figure C-1).
4
Motherboard header
3
Retention feature in installed position
4
Chapter 3 Maintaining the Server
3-6.
3-7.
Figure 3-25.
2
1
Embedded RAID Controller,
OL-26646-01