CONVECTAIR APERO 7359 BB Installation & Operating Instructions Manual

CONVECTAIR APERO 7359 BB Installation & Operating Instructions Manual

Electric heater

Advertisement

APERO
7359 BB
Installation,
Operating Instructions &
Warranty Registration
IMPORTANT :
to be read and kept by the user

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the APERO 7359 BB and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for CONVECTAIR APERO 7359 BB

  • Page 1 APERO 7359 BB Installation, Operating Instructions & Warranty Registration IMPORTANT : to be read and kept by the user...
  • Page 2: Planning The Installation

    Dear owner, - Congratulations on the purchase of this new premium electric heater from CONVECTAIR, manufacturer of the highest quality heating product in the electrical industry. - To obtain the best results and the ultimate in performance and comfort please carefully read the installation and maintenance instructions shown in this manual.
  • Page 3: Installation

    Installation Figure 3a 3 conductor wiring should be used if you are planning to use this unit with the CONVECTAIR Heater Width Programmer (see Technical Sheet). " 80 mm " 440 mm " 100 mm min. 500=>1250W Largeur WATTS Appareil...
  • Page 4: Electrical Connection

    4- Carefully put back all wires inside the box, close and screw the cover. 5- Hook the CONVECTAIR unit onto the mounting bracket tabs with the unit slightly angled towards you. Push the CONVECTAIR towards the wall until it is engaged on both locking brackets.
  • Page 5 How to use your heater CONVECTAIR heaters operate in short cycles. The red indicator light tells you when heat is on. The CONVECTAIR will always remain warm and ambient temperature will remain constant. It is normal in very cold temperatures for the unit to become hot. Caution is advised when young children are present.
  • Page 6 2- Turning the thermostat ON or OFF (standby) : MODE To start the heater press the Mode key once. The VECTORISE VECTORISE MODE display will show the current thermostat setting (factory default is 19°C). To place the heater on Standby (no heat), press the MODE Mode key repeatedly until the display shows “--”.
  • Page 7 5- SETBACk (ECONOMY) MODE : When the heater is in EC Mode, it will maintain the temperature at a lower value. This setting is useful to reduce energy consumption at night or when a room is temporarily unused. To select the EC mode : Press the Mode key briefly until the letters EC appears on the display.
  • Page 8 MODE 7- LOCkING THE HEATER CONTROLS : The control pad can be locked from any Mode selection to prevent tampering. To lock the control : From any Mode setting, press MODE both the + and the – key at the same time and hold for about 3 seconds.
  • Page 9: Maintenance

    Convectair (Figure 6). never use abrasive or aceTone-based producTs To clean The heaTer as This may cause deTerioraTion of The epoxy finish. any repair on your convecTair heaTer should only be done by a qualified Technician afTer disconnecTing The heaTer.
  • Page 10 Operation and Maintenance TIPS Your CONVECTAIR heater will become hot when in use. Caution is advised when young children are present. Do not insert small objects through the front louvers : this could cause electrical short- circuit, fire or damage to the inner components.
  • Page 11: Warranty

    2 years against all defects 5 years on heating element All CONVECTAIR units are subject to a double warranty: 2 years on all parts and manufacturing defects and 5 years on the heating element itself. Warranty is applicable from date of purchase by the customer and under certain specific conditions.

Table of Contents

Save PDF