Cleaning The Condenser - Perlick SDBR48 Installation & Operation Manual

Cleaning the Condenser

The condenser (located behind front grille cover)
should be cleaned every three (3) months. Use
a soft bristle brush and vacuum to remove the
dust and lint.
Job
Routine cleaning.
Fingerprints and smears.
Stubborn stains and discolorations.
Heat tint or heavy discoloration.
Tenacious deposits, rust, discoloration,
industrial atmospheric stains.
Rust discoloration or corrosion caused
by cleaning agents containing hydro-
chloric (muriatic) acid or chlorine bleach
Use of property names is intended only to indicate a type of cleaner and does not constitute an endorsement. Omission of any proprietary
cleaner does not imply its inadequacy. All products should be used in strict accordance with instructions on the package.
NOTE: Do not use steel wool or scouring pads to clean stainless steel.
Printed in USA
Recommended Cleaners for Specific Situations
Cleaning Agent
Soap, ammonia, detergent
Areal 20, Lac-O-Nu, Lumin Wash,
O'Ceder Cream Polish
AllChem Concentrated Cleaner, Samae,
Twinkle, Cameo Copper Cleaners, Grade
FFF Italian Pumice Whiting, Steel Bright,
Lumin Cleaner, Zud Restoro, Sta-Clean,
Highlite Cooper's Stainless Steel Cleaner
or Revere Stainless Steel Cleaner.
Old Dutch, Lighthouse Sunbrite,
Wyandotte Bab-O, gold Dust, Sapollo,
Bon Ami or Comet.
Liquid NuSteel or Dubois Temp
Penny-Brite, Copper Brite, Paste Nu-
Steel, Dubois Temp or Tarnite
Bar Keepers Friend, Revere Stainless
Steel Cleaner, Allen Polish, Steel Bright
Wyandotte Bab-O or Zud.
Oakite No. 33 Dilac, Texo NY, Flash-
Klenz Caddy Cleaner, Turco Scale 4368
or Permag 57.
3M Scotch Brite pad, type A Grade "Fine" Clean off the surface soil using cleaning
Models SDB/SDP Installation & Operation Manual
CAUTION
fins or tubing. Failure to follow this procedure
may damage the compressor and void the
warranty.
Apply with sponge or soft cloth.
Provides barrier film to minimize finger-
prints. Can be used on all finishes. Rub
the surface with a cloth as directed on
the package.
Apply with a damp sponge or cloth, then
rinse with clear water and wipe dry.
For these household cleaners, rub with
a damp cloth. They may contain chlorine
bleaches so rinse thoroughly after use
and wipe dry
For these products, rub the surface with
a dry cloth using only a small amount of
cleanser. Rinse with water and dry.
Rinse and rub onto surface with a dry
cloth.
When using these cleaners, apply with a
damp sponge or cloth, rinse thoroughly
and wipe dry.
Use Swab and soak with a clean cloth. Let
stand for 15 minutes or more according
to directions on package then rinse and
wipe dry.
methods above. Then rub discolored or
corroded areas lightly with dry pad.
8
A v o i d d a m a g i n g o r
crushing the condenser
Comments
0213