Turning Off The Power ･･･････････････････････････････････････････19; Normal Power Off - Denso BHT-904BB User Manual

2.
Press the SCAN key to activate the Easy Pack Ad for BHT-900.
The screen on the right appears.
When the M1 key is pressed, the Easy Pack Ad for BHT-900
− Point −
is activated in the same manner as for the SCAN key. Note,
however, that the screen in step 1 is no longer displayed
after this point. To turn the power OFF, press the M2 key.
3.
When information loading is complete, the screen on the right appears.
For information on how to use the "Easy Pack Ad for BHT-900", first obtain the product from the
− Note −
QBdirect service (http://www.qbdirect.net/) and then check how to use the software.
2.6 Turning OFF the Power
You can turn OFF the BHT in one of the following three methods.
Methods

Normal power OFF

Turning the power OFF
after data back-up
Auto power OFF
2.6.1 Normal Power OFF
1.
Press the Power key (
The BHT turns OFF after the message on the screen given to the right
displays.
Do not remove the batteries while the message on the right
− Point −
is displayed.
When the power is next turned ON, there are times when a
message "Contact your administrator. (XXXX)" displays
asking the user to contact the administrator.
Operation
Press the Power key (
Hold down the Power key (
least 3 seconds.
The power turns OFF itself when the
BHT is not used for specified period of
time set at the user program.
).
Barcode Handy Terminal
Data back-up timing
). 20 minutes after the power is turned
off
) for at At the power OFF
20 minutes after the power is turned
off
19