Power; Intensity & Mode Setting - Colorado time systems QuickStart Pro User Manual

Power

AC Power
Battery
Power Switch
Intensity & Mode
Setting
Intensity
Mode
6
touchpad input, using an extension cable (CTS SJ series) with a
stackable, open-ended dual banana plug.
Connect the QuickStart Pro to AC power using the supplied (15
DVC) power brick. Plug the power brick 5-pin DIN connector into
the QuickStart Pro, and plug the power brick in to AC power.
An internal battery can supply power to the QuickStart Pro. A fully
charged battery will run the unit for a minimum of 6 hours. Leave
the unit plugged in overnight to fully charge the battery after use.
The battery charges any time the unit is plugged in to AC power.
The power switch is on the right side of the QuickStart Pro, next to
the DIN connector for the power brick.
Use the Mode switch on the right side of the QuickStart Pro to set
the intensity of the LED digits as follows:
When a QuickStart Pro is turned on, it will first display
sity. While is displayed, the Mode switch adjusts the intensity of
in
the display. Eight levels of intensity are available, from 1 (low) to 8
(high). These same settings can also be selected from 9 (low) to 16
(high).
After the Mode switch has been in the same intensity setting for 4
seconds, the clock will display the firmware revision, and then the
current mode. At this point, the Mode switch changes the mode. The
Mode switch will change only the mode until the clock is turned off
and then on again.
for Inten-
in