Table of Contents
Advertisement
5.2.2 Setting the height
The stabiliser tube is height-adjustable.
Loosen the locking screws (fig. 64/
position the stabiliser tube (fig. 50/
according to the driving wheel. Re-
tighten screws.
Attention:
!
To provide sufficient stability from tip-
ping, both stabilisers must be set to
the same height.
5.2.3 Correct stabiliser length
In order to ensure sufficient support, the
stabilisers must extend beyond the driv-
ing wheel.
5.3 Tread cap
The tread cap (fig. 65/
) is used by
the carer to tilt the wheelchair when
negotiating obstacles and can be
mounted on the right or left.
5.3.1 Setting the height
To set the height, loosen the locking
screws (fig. 65/
). Re-tighten locking
screws when adjustment is complete.
44
),
)
2
64
2
1
65
5.4 Lateral supports
The lateral supports (fig. 66/
the sitting stability and can be adjusted
in height and swivelled to the rear.
1
5.4.1 Setting the height
The lateral supports can be suitably po-
sitioned after the locking screws (fig. 67/
) have been slackened. Re-tighten
screws.
5.4.2 Setting the depth
The lateral supports can be suitably po-
sitioned after the locking screws (fig. 67/
) have been slackened. Re-tighten
screws.
5.4.3 Swivelling the lateral sup-
ports to the rear
The lateral supports can be swivelled to
the rear after they have been pulled up
out of the locking device (fig. 68).
) increase
66
2
67
68
1
3
45
Advertisement
Table of Contents
