Main Menu - Danfoss DHP-A User Manual

User Guide
Message
ROOM
START
EVU STOP
NO HEAT DEMAND
HEAT PUMP START --
XX
HEAT PUMP
+ADD.HEAT
START_MIN
ADD. HEATER
COOLING
ACTIVE COOLING
DEFROST X(Y)
4.4

Main Menu

The display's INFORMATION menu is used to set and adjust the heat pump functions and is opened by pressing
the left or right button. The menu has the following appearance:
2
INFORMATION
3
OPERAT.
HEAT CURVE
TEMPERATURE
OPERAT. TIME
4
DEFROST
Use the + and - buttons to move the cursor between the sub-menus. Use the right button to select a sub-menu.
Use the left button to go back in the menu.
Danfoss Heating Solutions
Domestic heat pumps
Meaning
Shows the set ROOM value. Standard value: 20°C.
If the room sensor (accessory) is installed it shows the actual temperature, while the
desired indoor temperature is shown in brackets.
Indicates that there is a need for heat or hot water production and that the heat
pump will start.
Indicates that the additional function EVU (Elektrizitätsversorgungsunternehmen) is
active. This means that the heat pump is off as long as EVU is active.
Indicates that there is no demand for heating or hot water production.
Indicates that there is a need for heat or hot water production and that the heat
pump will start in XX minutes.
Indicates that heat production is active with both compressor and immersion heater.
Indicates that there is a demand for heating or hot water production but that a start
delay is active.
Indicates that there is an auxiliary heater demand.
Displayed when passive cooling is produced.
Displayed when active cooling is produced..
Displayed when defrosting is active. X shows the actual temperature reached. Y
shows at which temperature defrost is complete (applies to DHP-A ).
1 Sub-menus
2 Return
3 Cursor
1
4 If an arrow is shown, it indicates that there are further sub menus
VUGFE102
13