Operation - DeVilbiss FLG-S5-18 Operation Manual

E
E
Important: To ensure that this equipment
reaches you in
protective coatings have been used. Flush
the equipment through with a suitable
solvent before use.
1. Attach air hose to connector (19).
Recommended hose size 8 mm bore.
The hose must be conductive and
electrical bond from the spraygun to
earth should be checked with an
1. Mix coating material to manufacturers
instructions.
2. Fill the cup with the required amount of
material. Fill to no more than 25mm (1")
from the top of the cup. DO NOT
OVERFILL.
3. Attach Cup to the Lid assembly.
4. Turn needle
clockwise to prevent movement.
5. Turn spreader
clockwise to fully open.
6. Adjust inlet
r e c o m m e n d e d
Specifications) at the gun inlet with the
gun triggered.
attachment shown under Accessories is
recommended for this).
7. Turn needle adjusting screw counter
clockwise until first thread shows.
8. Test spray. If the finish is too dry reduce
airflow by reducing air inlet pressure or
1. Turn off air and relieve pressure in the
supply lines, or if using QD system,
disconnect from airline.
2. Release Cup and raise the tube out of
the material. Trigger the Gun and allow
material to drain back into the cup.
Dispose of the surplus material.
3. Clean the cup. Remove the Drip free
diaphragm (if fitted) and clean. Replace
the diaphragm if is split or damaged.
4. Check the breather hole in the Lid is
© 2005 ITW Finishing Systems and Products
Installation
first class condition,

Operation

adjusting screw
valve (10) counter-
air pressure
f i g u r e s
(pressure gauge
Preventative Maintenance
ohmeter. A resistance of less than 10
Ohms is recommended.
2. Attach the Cup Lid assembly (38) to the
Fluid Inlet connector (28).
3. Position the Yoke at right angles to the
Gun with the Cam lever (32) to the front
(see picture). Make sure the vent hole
in the lid is positioned under the Yoke
and the hole in the diaphragm (KR-115)
if fitted is 180° to the Lid vent hole.
by the Airflow Valve (22). Screw the
Adjusting Knob in to reduce pressure.
9. If finish is too wet reduce fluid flow by
turning needle screw (18) clockwise or
reducing
atomisation is too coarse, increase inlet
air pressure. If too fine reduce inlet
(18) pressure.
10. The pattern size can be reduced by
turning adjusting valve (10) clockwise.
11. Hold gun perpendicular to surface being
(For sprayed. Arcing or tilting may result in
s e e uneven coating.
12. The recommended spray distance is
150-200 mm (6"-8").
13. Spray edges first. Overlap each stroke a
minimum of 50%. Move gun at a
constant speed.
14. Always turn off air supply and relieve
pressure when gun is not in use.
not blocked.
5. Remove air cap (2) and clean. If any of
the holes in the cap are blocked with
coating material only use the Cleaning
Kit KK-4584 (see accessories) which
has the correct tools for this or a
toothpick to clean. Using any other tool
could damage the cap and produce
distorted spray patterns.
6. Ensure the tip of the nozzle (3) is clean
and free from damage. Build up of
6
the fluid pressure.
6
If