Login Ip Camera - NST CPT2IP User Manual

network parameter in accordance with the computer, and it will be ok.
Network parameters configuration instructions:

Please review the upper left corner of the computer, if the computer has multiple network cards,
select the card that is being used, while ensuring that the IP Camera is in the corresponding network.
Modify the last octet of the CPT2IP IP Address, and ensure that the gateway and subnet are the same

as in the LAN and the CPT2IP.
If you are not sure exactly how to change the IP Address, you can also check the "automatically

obtain an IP address", the IP Camera will then obtain an IP address directly from the router (If you
can not obtain an IP address from the router, you need to check the "specify an IP address
manually", then fill in an available IP Address, Subnet Mask and Gatway for your LAN).
The Administrator password must be correct,

admin), click on the "save your settings" button, setting will take effect. Next, select the device in
the device list box. Double-click it, it will automatically open the browser and a pop-up dialog box
to access the device's user name and password promts, you can then enter into the main page of the
CPT2IP IP Camera, as shown in Picture 16
Note: If your computer is equipped with firewall software, when running IPCamera.exe,
you will be prompted whether to block the program, please choose Allow access for connection.
1. Camera information means the network camera information
2. Computer has a fixed IP (ie, non-DHCP-IP), the first time you use the network camera, click.
,So that the network camera's IP address, gateway and DNS synchronize with computer.
3. To manually modify the name of the camera, the HTTP port, IP address, subnet mask, gateway, DNS
servers, etc., please click the Save Settings after modifying.
4.3

Login ip camera

The computer will open the device according to its default browser. Running ActiveX mode in Internet
●
Explorer (IE) to access for example. Double-click the selected IP devices with the left mouse button
Or enter the IP address of the device in the browser directly, you can enter into the landing of the
verification page of the device in both two ways (for example: http://192.168.1.111:8999). As shown
in picture 13:
：
(Factory default user name is: admin; password:
Picture 12
IPCAM User Manual
12