Visit Ip Camera In Lan; Connect In Lan; Search And Set Device Ip Address - NST CPT2IP User Manual

4

Visit Ip Camera in LAN

4.1

Connect in LAN

Picture 10
4.2

Search and set device IP address

Please note before searching IP camera：
1：Make sure IP camera has a good connection with power and network.
2：The router should be opened DHCP(
status of IP camera is to obtain automatically IP camera.
3：When powering CPT2IP, expect to wait 20 seconds for unit to power up
 Search IP camera
When we run Search tool" IP camera Tool", we can find the IP camera showing IP
address, Port, Name. If we use Wi-fi connection, we will find Wi-fi IP address. For
the details, we can view the following picture.
Note： （ "IP Camera Tool.exe"Program is for use to search IP camera address and port in
the LAN. The tool can't search IP camera IP address and port in the WAN.
There are 3 situations:
1 Can not find the device and (re-search) can not locate it in the LAN, please check whether the power
and network cable are working properly.
2 Searching for the device in LAN, all the devices will be listed as shown in Picture 12.
3 Devices installed in the LAN, but not in the same network segment where the computer and the
IP Camera are in. The device's IP address will be listed, but you can not turn the camera on, just change
the
Connection between Several IP camera and router
Dynamic host configuration protocol) because the factory setting
Picture 11
IPCAM User Manual
11