Table of Contents
Advertisement
System expansions
Installing and removing drives
The system unit houses a total of three accessible drives (two 5 1/4-inch drives and one 3 1/2-inch
drive) and one non-accessible half-height (Slimline) drive.
IDE drives
By default four IDE drives are supported. Ideally hard disks are connected to IDE port 1, and
accessible drives, for example CD-ROMs, to IDE port 2 (see also the Technical Manual for the
system board).
Installing an accessible drive
Ê
Open the system unit (see "Opening the system unit").
1
Ê
Pry the plastic drive cover (A) out of the front cover.
Ê
Pry the shielding plate (B) on left-hand side out of the bay.
Do not to throw away the plastic covers. For cooling, protection against fire and in order to
i
comply with EMC regulations, you must refit the plastic covers if you remove the drive
again later.
Ê
Take the new drive out of its packaging.
Ê
Make the required changes to the drive settings (if necessary, to the settings of installed drives
as well).
40
2
Installing and removing drives
B
A
A26361-K831-Z101-1-7619
Advertisement
Table of Contents
