Harman Super-Magnum Coal Stoker Stove Owner's Manual Installation And Operation page 29

Super-Magnum Coal Stoker Stove
3. Distribution Blower
Requires no lubrication.
Change filter monthly to prevent build up of pet hair,
etc.
To remove distribution blower;
• Remove filter retainer and filter.
• Disconnect the three wires from the blower power
cord.
• Loosen 3 mounting screws which hold the motor
into its housing.
• Lower the motor and squirrel cage fan out of the
blower housing.
Mounting
Screws (3)
3-90-02702R4_08/12
4. ESP- (Exhaust Sensing Probe)
Remove and wipe clean with a soft cloth and glass
cleaner or alcohol.
To remove the probe, you'll need to access the panel
in the fuel hopper.
• Remove the knob from the heat exchange scraper
handle. The knob is threaded onto the shaft.
• Remove the access panel by loosening the screws.
• With a 1/4" socket or driver, remove the screw that
attaches the probe.
• Pull the probe out of it's mounting hole.
Access Cover
Scraper Knob
ESP (probe)
5. Fines Scraper- in feeder
In the base of the hopper, there is a scraper plate
that keeps the coal fines flowing toward the fire. This
scraper plate is designed to be adjustable. To adjust,
loosen the two bolts with a 7/16" wrench, allow the
scraper plate to rest downward against the top of the
pusher block, and re-tighten the two bolts.
THIS VIEW IS LOOKING STRAIGHT DOWN
INTO THE HOPPER.
LOOSEN THESE TWO BOLTS TO ADJUST
THE SCRAPER.
29
Do Not Burn Wet Coal!