Table of Contents
Advertisement
Note: Make sure that you are installing the correct LavaPort-Quad
drivers for the appropriate operating system.
DO NOT install NT or Windows 3.x drivers under other
1. With the power turned off, insert the LavaPort-Quad card into any
free PCI slot in your PC. Make sure the card is well seated. Insert the
bracket with Ports 3 and 4 into a free slot. If you must detach the
cables from the card to do so, be sure to re-install the cables back
onto the card with the red wire corresponding to the "1" on the
board.Turn your PC on and start Windows.
2. Windows will automatically detect the LavaPort-Quad as a new PCI
Serial Controller and ask you to insert the Lava Installation Diskette.
The installation files are located in either the root or the Win95
subdirectory of this disk. On some PC's you may have to manually
type A:\WIN95 when prompted for the Lava Installation Diskette.
3. After the necessary files have been copied, Windows will complete
the full installation of the
LavaPort-Quad Parents will be created in Device Manager under
Multi-Function Adapters, and four child ports will be created under
Control Panel | System | Device Manager | Ports.
Windows Installation
Windows Driver Installation
versions of Windows
LavaPort-Quad
. During this process, two
6
Advertisement
Table of Contents
Need help?
Do you have a question about the LavaPort-Quad and is the answer not in the manual?
Questions and answers