Related Manuals for Lava 2SP-PCI
Summary of Contents for Lava 2SP-PCI
- Page 1 Lava 2SP-PCI Installation Manual SERIAL 2 MADE CANADA LAVA COMPUTERS 2SP PCI P.N. MOKO L73.1 Rev. B00...
- Page 2 1. Before opening the casing of your computer, make sure that all power is off. 2. Locate an unused PCI slot and insert the 2SP-PCI card into it. Ensure that it is well seated, and screw the metal bracket of the board to your PC’s casing.
- Page 3 5. When Windows starts, it will find a 2SP-PCI Controller and will ask you for a driver for this device. When prompted, insert the installation diskette into your floppy drive. After copying the necessary files from the diskette, Windows may restart your PC in order to complete the installation of the 2SP-PCI card.
- Page 4 PCI device, its default address (Input/Output Range) is beyond the standard range of ISA I/O addresses. In order to connect such a peripheral to the 2SP-PCI card, the I/O address range of the card must therefore be changed manually.This section describes how this is done.
- Page 5 2. Remove the check mark from the Use Automatic Settings box. Note: In some cases Windows will give an error message to the effect that "Windows cannot modify this resource" at this point. If you are unable to access the settings for changing system resources, reboot the system in Safe Mode to make changes to resource settings.
- Page 6 Unless you already have more than 4 Com Ports installed in your PC, Windows will by default configure the serial ports of the 2SP-PCI as Com 5 and Com 6. If you wish to change the assigned Com number of either of these ports (e.g.
- Page 7 2SP-PCI card Installation diskette. Instructions for Linux installation are available at www.lavalink.com. B. Because the 2SP-PCI card uses PCI (not ISA) I/O address ranges, it will never be seen by your BIOS at boot-up as a standard port even if the address has been changed in Windows using the above procedure.
-
Page 8: Technical Support
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Lava Computer MFG Inc. 908 Niagara Falls Blvd. #629. North Tonawanda NY 14120-2060...
Need help?
Do you have a question about the 2SP-PCI and is the answer not in the manual?
Questions and answers