Harris Intraplex STL-160 Series Installation & Operation Manual page 79

4 – Setup & Configuration
Table 4-1. CM-5RB Basic Configuration Group (continued)
Group Selections
SIO
BAUD 110
300
1200
2400
4800
9600
19.2
57.6
PAR Spac
Mark
Even
Odd
exit
LOCK
COMM
CNFG OFF
(Default)
MSTR
SLV
BRDG
RATE 8 KB
16 KB
(default)
32 KB
64 KB
TSLT 1 to 24
REDN
MRDN
LRDN
On power-up, the 4-character display on the front panel indicates the multiplexing mode on the
primary CM-5RB module (Table 4-2). If a backup CM-5RB module is installed, it always reads BKUP
during power-up.
Harris Corporation
Intraplex Products
ACS-160 Series & STL-160 Series T1 Multiplexer Installation & Operation
Description
Serial input and output settings (Section 5.1.1.3 – Configuration - Remote
Port Parameters (SIO Group) Setting)
RED = not selected, GREEN = selected
Sets baud rate to 110 bps.
Sets baud rate to 300 bps.
Sets baud rate to 1200 bps.
Sets baud rate to 2400 bps.
Sets baud rate to 4800 bps.
Sets baud rate to 9600 bps.
Sets baud rate to 19.2 kbps.
Sets baud rate to 57.6 kbps.
Sets parity to space.
Sets parity to mark.
Sets parity to even.
Sets parity to odd.
Exit PAR and display Lock.
Locks and unlocks the serial port.
Network communications parameters (Section 5.1.2 – DS0 Management
Communications)
Turn network communications off.
Sets the multiplexer to master mode.
Sets the multiplexer to subordinate mode.
Sets the multiplexer to bridge mode.
Sets the data rate to 8 Kbps (1 bit/DS0).
Sets the data rate to 16 Kbps (2 bit/DS0).
Sets the data rate to 32 Kbps (4 bit/DS0).
Sets the data rate to 64 Kbps (8 bit/DS0).
Time slot for T1 DS0 (time slot 24 is the default)
Common module redundancy settings – Only seen on redundant CM-5RB
common modules (Section 4.6 – Redundant CM-5RB (REDN Group))
Never switch to a backup.
Version 2.11, August 2011
4-5