Harris Intraplex STL-160 Series Installation & Operation Manual page 113

5 – Remote Control
5. At Table of Contents, click Intraplex.
6. At the Intraplex Table of Contents, click IntraGuide.
7. At Download Name, click the link. The File Download dialog box appears.
8. Click Save.
9. Navigate to the location you want to store the IntraGuide software on your computer and click
Save.
Once you have loaded the IntraGuide software, perform these steps to access it:
1. Ensure that the cabling is properly connected from the equipment to the PC (Sections 3.6.4 and
5.1.1.1):
• If you are connecting directly from your computer to the CM-5RB remote port, ensure that the
RS-232 cable is properly connected.
• If you are using IntraGuide software over an IP network, make sure that
◦ The CM-5RB remote port is properly connected to an SCM-IP module.
◦ The SCM-IP module is properly installed and configured.
◦ The SCM-IP module is connected to the same IP network as the computer running the
IntraGuide software.
2. Ensure that each of the channel modules is set to REMOTE. If the REMOTE is not enabled, you can
still read the setting from the channel modules, but you cannot make changes to the
programmable module settings.
3. Click the Start on the taskbar.
4. Click Programs | IntraGuide.
5. On the menu bar, click Setup | Communication Interface | Configure Serial Port. The
Communication Settings dialog box appears.
6. Use this dialog box to view, edit, add, or remove configurations as needed.
7. Click Setup | Auto Detect Devices to allow the software to go online with the equipment and
build an equipment list.
8. Follow the prompts to detect the channel modules.
Note: To see the latest list of IntraGuide-compatible modules in the IntraGuide Help, go to Help |
Help Topics on the menu bar, click Common Modules and Channel Modules on the
Contents tab, and then click List of Common Modules and Channel Modules.
5.2.1.3 IntraGuide Help
The IntraGuide Help tool covers both IntraGuide software and Intraplex equipment. The Help is also
context-sensitive and is designed to give you with all information required to use IntraGuide software.
Click Help on the IntraGuide menu bar to open the Help tool.
5.2.1.4 Sample Configurations Using IntraGuide
IntraGuide can control the functionality of most modules. The IntraGuide Help provides context-
sensitive information about operating the IntraGuide interface. Figure 5-11 shows the CM-5RB
configuration interface.
Harris Corporation
Intraplex Products
ACS-160 Series & STL-160 Series T1 Multiplexer Installation & Operation
Version 2.11, August 2011
5-15