Harris Intraplex STL-160 Series Installation & Operation Manual page 78

Intraplex stl-160, intraplex acs-160 series t1 multiplexer
Table of Contents

Advertisement

ACS-160 Series & STL-160 Series T1 Multiplexer Installation & Operation
Version 2.11, August 2011
Table 4-1. CM-5RB Basic Configuration Group (continued)
Group
Selections
LPBK
LnLB
PaLB
EqLB
BLNK
Rx11
Tx11
TxYl
RxYl
FTIM
NLLB
NPLB
XsJt
RVU1
TxLk
RxLk
TxRx
XsJt
DIAG
T1 or CSU
X.XX
Fcty
ADDR
0000
TDLY
TDSA
LCL
4-4
Description
Loopback modes (Section 6.3.1 – T1 Loopbacks Use (LPBK Group))
Indicates line loopback mode.
RED = not in line loopback mode
GREEN = in line loopback mode
Indicates payload loopback mode.
RED = not in payload loopback mode
GREEN = in payload loopback mode
Indicates equipment loopback mode.
RED = not in equipment loopback mode
GREEN = in equipment loopback mode
Receiving all ones (Section 6.3.2 - Blinking Indicator Lights (BLNK Group))
Transmitting all ones ("keep alive circuit" or AIS)
Transmitting yellow alarm
Receiving yellow alarm
Fall back timing
Network requested line loopback
Network requested payload loopback
Excess jitter on T1 has been detected
Transmit phase loop lock status (Section 6.3.3 - Performance Data Review
(RVU1 Group))
RED = unlocked, GREEN = locked
Receive phase loop lock status
RED = unlocked, GREEN = locked
Transmit /receive clock lock
RED = unlocked, GREEN = locked
Jitter buffer status
RED = OK GREEN = Buffer exceeded
Channel service unit (CSU) displays when the CM-5RB module is connected to
the MA-215/MA-235-1/MA-235-2 or T1 displays when the CM-5RB module is
connected to the MA-217B (Section 6.3.4 – Other Diagnostic Data (DIAG
Group))
Current version of the loaded firmware
Status of settings
RED = Not factory setting, GREEN = Factory settings
Multiplexer address number 0000 to 9999 (Section 5.1.1.2 – Configuration –
Network Address (ADDR Group) Setting)
Time delay control for units with optional delay capability (CM- 5RTD module)
– Section 4.7 – Optional Integrated CM-5RTD Time Delay (TDLY Group)
Time delay subaddress (1-36)
Local control
RED = local control off, GREEN = local control on
4 – Setup & Configuration
Harris Corporation
Intraplex Products

Advertisement

Table of Contents
loading

Table of Contents