Gigabit Ethernet; Extra Bell And Busy Signal; Wall Mounting - Aastra 7433ip User Manual

IP P MX-ONE™
HONE FOR
2.10.1
2.10.2
2.11
25
Note: When an option unit is installed, the LAN cable must be
connected to the port marked Net on the option unit. Otherwise,
the phone will not work.
To remove the option unit, do the following:
1. Disconnect all cables attached to the option unit.
2. Press the unit in the opposite direction to when you installed it.
3. Disconnect the ribbon cable.

Gigabit Ethernet

The option unit offers a Gigabit Ethernet interface module, the purpose
of which is to pass on gigabit traffic to the PC connected to the IP
terminal. The phone itself does not require the gigabit speed.

Extra Bell and Busy Signal

The option unit offers an interface for auxiliary equipment, such as an
external bell or an busy signal indicator. There are three alternatives
using this function:
Busy Signal
The busy signal is activated in off-hook mode. Can be used to
control a Do-not-disturb lamp at the door.
Extra Bell
The extra bell is activated parallel to the ring signal.
Combined Bell/Busy
A combined busy signal and extra bell. Steady active in off-hook
mode, and flashing when the phone rings. Can be used for lamp
indication in an office landscape, for example.
See 13.6 Option Unit (Optional) on page 88 for instructions on how to
make these settings.

Wall Mounting

The phone can be wall mounted. For detailed information on how to do
this, please see the installation card which comes with the phone.
6/1553-DBC 433 01 Uen B6 2010-07-09