Disassembly Procedure - Mitsubishi Electric PKH18FK1 Technical & Service Manual

13

DISASSEMBLY PROCEDURE

PCH24FK
1
OPERATING PROCEDURE
1. Removing the air intake grille
(1) Unhook the clasps at the edge of the grille and open the
grill.
(2) Lift up the grill in direction of arrow 1 in Figure.2.
(3) Pull the grill toward you to remove. (In direction of arrow 2)
2. Removing the side panel
(1) Remove a white screw of the side panel (RIGHT).
(2) Pull out the panel toward you to remove.
(3) Remove a white screw of the side panel (LEFT).
(4) Pull out the panel toward you to remove.
3. Removing the lower panel
(1) Remove the lower panel set screws, 2 pcs on each side
and 3 pcs at the rear. (total 7 pcs)
W PCH24EK has 4 pcs at the rear and 2 pcs on each
side. (total 8 pcs)
4. Removing the electrical box
(1) Remove the air intake grille. (Refer to 1.)
(2) Remove the support bar set screw and remove the bar.
(See figure. 4)
(3) Loose the lead clamps (2 pcs) for the sirocco fan and the
louver motor. (See photo 1)
PHOTOS&ILLUSTRATION
Figure 1
Side panel (L)
Air intake grille
Figure 2
2
1
Figure 3
Figure 4
Photo 1
Electrical box
OC193-56
Lower panel
2
1
Side panel (R)
Lower panel
Support bar
Clamps for fan lead