Table of Contents
Advertisement
12
DISASSEMBLY PROCEDURE
PKA-M60KA2(-ER/-ET).TH
PKA-M60KAL2(-ER/-ET).TH
OPERATION PROCEDURE
1. Removing the panel
(1) Press and unlock the knobs on both sides of the front
grille and lift the front grille until it is level. Pull the hinges
forward to remove the front grille. (See Photo 1)
(2) Remove 3 screw caps of the panel. Remove 5 screws.
(See Photo 1)
(3) Unfix 3 hooks. (See Figure 1)
(4) Hold the lower part of both ends of the panel and pull it
slightly toward you, and then remove the panel by pushing
it upward.
(5) Remove the screw of the corner box. (See Photo 1)
Remove the corner box.
2. Removing the indoor controller board and the wire-
less controller board
(1) Remove the panel and the corner box. (Refer to procedure 1)
(2) Remove the front and side electrical box covers (each 1
screw). (See Photo 2)
(3) Disconnect the connectors on the indoor controller board.
(See Photo 3)
(4) Remove the switch board holder and open the cover.
(5) Pull out the indoor controller board toward you then remove
the indoor controller board and switch board. (See Photo 3)
(6) Remove the holder of wireless remote controller board.
(7) Disconnect the connector of wireless remote controller
board and remove the wireless remote controller board
from the holder.
TCH069A
PKA-M71KA2(-ER/-ET).TH
PKA-M71KAL2(-ER/-ET).TH
33
PKA-M100KA2(-ER/-ET).TH
PKA-M100KAL2(-ER/-ET).TH
Be careful when removing heavy parts.
PHOTOS & ILLUSTRATIONS
Photo 1
Front grille
Screws and screw caps
Figure 1
Hooks
Photo 2
Water cut
Screw of electrical
box cover (Front)
Photo 3
Terminal block (TB4)
Screws
Screw of the
corner box
Screw of electrical
box cover (side)
Switch board
holder
Holder of wireless
remote controller board
Indoor controller
board (I.B.)
Terminal block
(TB5*)
Room temp.
thermistor (TH1)
*KAL model: Optional parts
Advertisement
Table of Contents
