Sirius XM RAdio Onyx EZ User Manual page 43

Vehicle Installation
vii . The FM channel you selected
will be confirmed on the display
screen . The Onyx EZ
to the FM
9 . You should hear XM channel 1
through your vehicle's stereo
system . You are now ready to
activate your Onyx EZ .
10 . Go back to "Step 2: Install the Dash
or Vent Mount" on page 12 and
finish installing the Dash or Vent
Mount . Then the installation is
complete .
11 . If the selected FM channel doesn't
work well for you, work down the
list of FM channels until you find
one that allows you to hear XM
clearly . Each time, you will need to
tune your vehicle's FM radio to the
FM channel and then set your Onyx
EZ to transmit on the same FM channel (steps 7 & 8) .
If the signal reception is good, but there is no XM audio when tuned to channel
1, verify that both the Onyx EZ and your vehicle's FM radio are tuned to the
same FM channel (steps 7 & 8) . Also ensure the chosen FM channel is a suitable
one to use in your area (step 5) . Verify that nothing is plugged into the AUDIO
connector on the PowerConnect Vehicle Dock . Refer to "Troubleshooting" on
page 80 for additional help .
will tune
channel .
FM Channels
FM 1 97.9
FM 2 _ _ _
FM 3
_ _ _
FM 4
_ _ _
FM 5
_ _ _
99.3 FM
Set your vehicle
radio to the above
channel to enable
audio.
current
43