Reprogram Request - Motorola Astro Digital Saber II User Manual

Special Radio Features
2. Talk and listen as usual.
3a. For Radios Using Only Softkeys for
Zone and Channel Selection —
When the dynamic regrouping is
cancelled by the dispatcher, the
radio will automatically return to
the original softkey zone and
channel before the radio was
dynamically regrouped.

• Reprogram Request

This feature allows you to notify the dispatcher that you want a new
dynamic-regrouping assignment.
1a. Press until the
appears on the display.
2. Press directly below
3. The display changes to show "REPROGRAM RQST," and the reprogram
request is automatically sent to the dispatcher.
4a. If you hear one beep, press the
PTT Switch to resend the
reprogram request again, or
pressto hang up and return to the
home display.
If the dispatcher fails to
Note
acknowledge the
reprogram request within
six seconds, a low-pitched
alert tone sounds and the
display changes to "NO
ACKNOWLEDGE." Try
again or press.
52
3b. For Radios Using Knobs or
Switches for Zone and/or
Channel Selection—
When the dynamic regrouping
is cancelled by the dispatcher,
OR
the radio will automatically
return to the present knob/
switch zone and/or channel
position and the original softkey
zone or channel selection.
softkey 1b. Press the Reprogram Request
Button (see page 2); then go
OR
to step 3.
.
4b. If you hear five beeps, the
reprogram request was
acknowledged by the
dispatcher, and your radio
will return to the home
display.