Battery Installation And Removal - Motorola Astro Digital Saber II User Manual

Battery Installation and Removal

DO NOT replace the battery in an area labeled "hazardous atmosphere."
If your radio is programmed with volatile-key retention (consult your
service technician), encryption keys will be retained for approximately
1. Make sure your radio is
turned off.
Removing the battery
Note
while the radio is on will
no longer erase the
encryption keys.
2. Hold the radio in your hand
with the back of the radio facing
up and slide the battery latch toward the top of the radio with your
thumb.
3. While holding the battery latch, slide the battery pack away from you
until it clears the radio.
4. To replace the battery, hold the radio in one hand. With the other hand,
slide the battery onto the radio's baseplate and toward the latch until it
"clicks" into place.
Batteries are shipped uncharged; they must be charged before use.
Note
Refer to the "Battery Charging and Disposal" section on page 71.
WARNING
!
To avoid a possible explosion:
DO NOT discard batteries in a fire.
CAUTION
!
30 seconds after battery removal.
Introduction
BATTERY
BASEPLATE INSERTION
BATTERY DIRECTION
LATCH
REMOVAL
DIRECTION
7