Battery Charging And Disposal - Motorola Astro Digital Saber II User Manual

Additional Information

Battery Charging and Disposal

• Charging Nickel-Cadmium Batteries
Charge the battery before use to ensure optimum capacity and performance.
The battery was designed specifically to be used with a Motorola charger.
Charging in non-Motorola equipment may lead to battery damage and void
the battery warranty.
When charging a battery that is attached to the radio, turn the
Note
radio off to ensure a full charge.
Do not attempt to change or charge the battery in a
hazardous atmosphere.
The battery should be at about 77°F (room temperature) whenever possible.
Charging a cold battery (below 50° F) may result in leakage of electrolyte and
ultimately, in failure of the battery. Charging a hot battery (above 95°F) results
in reduced discharge capacity, affecting the performance of the radio.
Motorola rapid-rate battery chargers contain a temperature-sensing circuit to
ensure that the battery is charged within these temperature limits.
Care should be taken to avoid external short circuiting of
the battery. A sustained high-rate discharge (for example,
a paper clip placed accidentally across the battery
contacts) may permanently damage the battery, void the
battery warranty, and create a burn or fire hazard.
• Recycling or Disposal of Batteries
This product is powered by a nickel-cadmium (Ni-Cd) rechargeable battery. At
the end of its useful life, the battery can be recycled. However, recycling
facilities may not be available in all areas. Under various state or local laws, the
battery must be recycled or disposed of properly and cannot be disposed of in
landfills or incinerators.
In addition, U.S. Environmental Protection Agency (EPA) regulations classify
used Ni-Cd batteries as hazardous waste, unless certain exemptions apply.
70
! WARNING
WARNING
!
NiCd