Operation Summary; Power Source - Whistler HIGH SURGE POWER INVERTERS Owner's Manual

OPERATION SUMMARY

• Before attempting to use a battery charger see page 18.
• Before attempting to use medical equipment see page 8.
• Use the heaviest gauge wire (smaller the number, the
larger or heavier the cable) available to connect the
inverter to the power source.
• When operating the inverter with the engine off, start the
engine every 30 to 60 minutes and let it run for at least
10 minutes to recharge the battery.
• In the event of automatic shut down, turn the inverter
OFF (O) immediately. Do not restart the inverter until the
source of the problem has been identified and corrected.
• To avoid battery drain always disconnect the inverter
when the vehicle is not in use for long periods.
• Do not expose the inverter to moisture.
• Avoid placing the inverter near sources of heat or in
direct sunlight.
• When in use, make certain that the inverter is properly
ventilated.
• Do not use the inverter near flammable materials,
fumes, or gases.
25