Power Source - Whistler HIGH SURGE POWER INVERTERS Owner's Manual

7. Turn the inverter ON (I). Check the Meter on the
front panel. The Voltage should read between 11
and 14 volts depending on the voltage of the power
source. If the reading is not within this range, check
the voltage of the power source and the terminal
connections on the power source and the inverter
to make sure they are secure.
8. Confirm that the equipment or appliance to be
operated is turned off. Plug the equipment or
appliance into one of the AC receptacles on the
front panel of the the inverter.
9. Turn the inverter to the ON (I) position. Turn on the
equipment or appliance.
Note:
• The audible alarm may make a momentary "chirp"
when the inverter is turned OFF (O). The same alarm
may also sound when the inverter is being connected
to or disconnected from the 12 volt power source.
Again, this is normal.
• The use of an extension cord from the inverter to
the appliance or equipment being operated will not
significantly decrease the power being generated
by the inverter. For best operating results, the
extension cord should be no more than 50 feet long.
OPERATION
17