Page 2
Our mission is to provide products that improve your driving experience. Whistler offers a complete line of DC to AC inverters ranging from 100 Watts to 3000 Watts. These inverters offer advanced technology, dependable operation and will provide years of reliable service when used in accordance with our operating instructions.
Page 5 A Word About Whistler Power Inverters Page Whistler inverters convert low voltage, direct current (DC) to 110 volt alternating household current (AC). The AC output is called “modified sine wave”. See “Technical Operating Principles” section for more information. Depending on the model and its...
Page 4
1. Three 110 AC Outlets 2. Remote Operation Jack The inverter is designed to be operated from a remote location via a WHISTLER Remote Control Switch (P/N Pro-RS01) which plugs into this socket. This optional accessory is available through WHISTLER or your WHISTLER dealer.
Notes: Your Whistler inverter is designed to operate from a 12 volt power source only. Never attempt to connect your Whistler inverter to any other power source, including any AC power source.
8:54 AM INVERTER INFORMATION Don’t Push It. Although your Whistler power inverter has the capacity to provide power output (excess current) equal to approximately two times its rated wattage capacity for a very brief period, it is designed to operate equipment and appliances with start up load wattage ratings no higher than its own maximum continuous wattage rating.
#4 gauge wire to make the connections. Within four to six feet, use a minimum of #2 gauge wire (Pro-1200W), #0 gauge for Pro-1600W. At distances between six feet to ten feet, use #0 gauge wire (Pro-1200W), #00 gauge for Pro-1600W. BATTERY/CABLE INFORMATION...
At distances between six feet to ten feet, use 2 sets of #00 gauge wires connected in parallel to the battery. Check Whistler’s online store for cable availability. Cable options: For model Pro-2500 at 10 foot length, a subsitute for the #0000 gauge can be using 2 sets of #0 gauge wires connected in parallel to the battery.
Reverse polarity will blow the internal fuses in the inverter and may cause permanent damage to the inverter. Damage caused by reverse polarity is not covered under the Whistler warranty. • Making the connection between the Positive (+) terminals may cause a spark as a result of current flowing to the capacitors in the inverter.
pro1200to3000w.qxp 4/30/2010 8:55 AM OPERATION • Check frequently to ensure that the input and output connections are secure. Loose connections may damage the inverter, the power source, or may generate excessive heat. To generate the maximum output, the Pro-3000W watt model (for example) should be connected to a power supply which has the capacity to produce up to 300 amps.
Page 11
pro1200to3000w.qxp 4/30/2010 8:55 AM OPERATION 2. Change the relative positions of the inverter, antenna cables and television power cord. 3. Isolate the television, its power cord and antenna cables from the 12 volt power source by running an extension cord from the inverter to the television set. 4.
Page 12
For You Technical Types. 1. Basic Operating Principles: Whistler inverters work in two stages. During the first stage, the DC to DC converter increases the DC input voltage from the power source (e.g. a 12 volt battery) to 145 volts DC. In...
8:55 AM OPERATING PRINCIPALS/SUMMARY In Review. • Never attempt to operate your Whistler inverter from any power source other than a 12 volt battery or a group of batteries that total 12 volts. • Always make certain that the power cable terminal connections Negative (-) to Negative (-) and Positive (+) to Positive (+).
pro1200to3000w.qxp 4/30/2010 8:55 AM TROUBLESHOOTING PROBLEM: TV Interference Problem Solution Electrical interference from Add a Ferrite data line filter inverter. on to the TV power cord. This filter is available at electronic supply stores. PROBLEM: Low or No Output Voltage Problem Solution Using incorrect type of...
8:55 AM SPECIFICATION Pro-1200W WATT INVERTER SPECIFICATIONS Maximum Continuous Power ....1200 Watts Maximum Surge Capability (Peak Power) ..2400 Watts No Load Current Draw .
Page 16
All express or implied warranties for this product are limited to (2) two years. Whistler is not liable for damages arising from the use, misuse, or operation of this product.
Page 17
(if applicable). Customer Service If you have questions concerning the operation of your Whistler inverter, or require service during or after the warranty period, please call Customer Service at 1-800-531-0004.