Installation 6; Hardware Installation - Vivotek IP7153 User Manual

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Hardware Reset
Status LED
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the indented reset button with a paper clip or thin object� Wait for the
Network Camera to reboot�
Restore: Press and hold the reset button until the status LED rapidly blinks� It takes about 30
seconds� Note that all settings will be restored to factory default� Upon successful restore, the
status LED will blink green and red during normal operation�
Installation

Hardware Installation

Follow the steps below to
1� Mount the lens by turning it clockwise onto the camera mount until it stops� If necessary, turn
the lens counterclockwise slowly until it gets the best attitude�
2� Connect the lens cable plug to the camera connector�
3� Unscrew the zoom controller to adjust the zoom factor� Upon completion, tighten the zoom
controller�
4� Unscrew the focus controller to adjust the focus range� Upon completion, tighten the focus
controller�
6 - User's Manual
mount the lens to the Network
1
2
Recessed Reset Button
Camera:
N
4
T
W
3