Jacuzzi Premium insulating cover in place at all times when the spa is not in use. Read and carefully follow the requirements for your spa’s support base found in section 4.0 titled, “Choosing a Location”...
3.0 Important Safety Instructions When installing and using this electrical equipment, basic safety pre- cautions should always be followed, including: READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THE SPA! 2. WARNING: To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times.
B. Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, pregnant or possibly preg- nant women should limit spa water temperatures to 100 °F (38 °C). If pregnant, please consult your physician before using a spa. C.
C. WARNING: People with infectious diseases should not use a spa. D. WARNING: To avoid injury, exercise care when entering or exiting the spa. WARNING: Do not use drugs or alcohol before or during the use of a spa to avoid unconsciousness and possible drowning. WARNING: Pregnant or possibly pregnant women should consult a physician before using a spa.
3.4 GENERAL ELECTRICAL SAFETY INSTRUCTIONS Your new Jacuzzi Premium spa is equipped with a "state-of-the-art" equip- ment system. It contains the most advanced safety and self-protective equip- ment in the industry. Nonetheless, this spa must be installed properly to insure dependable usage.
120/240 Volt Convertible Models A spa connected to a 120 VAC electrical service must be located close enough to a grounded, grounding-type electrical outlet so that the included power cord can be plugged directly into it. DO NOT USE AN EXTENSION CORD as this could cause damage to the spa’s equipment due to insufficient voltage.
When the spa is in use, considerable amounts of moisture will escape. This can damage certain surfaces over time. If you have any questions regarding the placement or installation of your spa, consult your authorized Jacuzzi Premium Dealer. Page 7...
5.0 Power Requirements Jacuzzi Premium spas are designed to provide optimum performance and flex- ibility of use when connected to the maximum electrical service listed in the tables below. If you prefer, your dealer can perform a minor circuit board modification to allow your spa to accept an electrical service other than the factory setting.
Page 13
US / Canada J-340 2-Pump Model (60Hz) 240V/50A* 240V/30A** Voltage: 240 VAC 240 VAC # of Wires: Frequency: 60Hz 60Hz Current Draw: Circuit Breaker: 50A, 2-Pole 30A, 2-Pole In 50A configuration, the heater will not operate while both jets pumps are running in high speed.
6.0 Electrical Wiring Instructions IMPORTANT NOTICE: The electrical wiring of this spa must meet the requirements of the National Electrical Code (NEC) and any applicable state or local codes. The electrical circuit must be installed by a qualified electrician and approved by a local build- ing/electrical inspection authority.
Page 15
Select the power supply inlet you want to use (Figure A). Feed power cable to control box, then install it through the large opening provided in the bottom side of the box. 8. Connect wires, color to color, on terminal blocks TB1 and TB3 (Figures C-F, Page 12).
Congratulations! You are now all set to get your new spa ready to use. Simply follow this step-by-step procedure and, before long, you will be enjoying your first glorious experience in your Jacuzzi Premium spa. For best results, read each step in its entirety before proceeding with that step.
Or, you may fill entirely with hard water if you use a special water additive available from your Jacuzzi Premium dealer. Always refill spa half way through both filter wall fittings to purge trapped air from pump intakes. Failure to do so may cause air to be trapped in either pump 1 or the circulation pump’s intake (air lock),...
8.0 Control Functions 8.1 Control Panel A. LED Display: can display current water temperature (default display), water temperature setpoint, selected filtration mode, and error mes- sages. B. Warmer ( + ) Button: increases water temperature setpoint. C. Cooler ( - ) Button: decreases water temperature setpoint. D.
8.2 Spa Features And Controls J-340 model illustrated - Location of Features Varies by Model Control Panel 1 1. Waterfall Feature 2. Air Controls 12. Heater Return Fitting 3. Filter/Skimmer Grill 13. Optional Audio System 4. Maxx PowerPro Jets Speakers (Available on 5.
The LIGHT button activates the spa light when pressed. The light has a one-hour default. 9.4 Selecting Desired Massage Action Your Jacuzzi Premium spa is equipped to allow you to customize the massage action you desire. Each model incorporates a diverter valve that Page 16...
9.9 Optional Audio System (J-340 Model Only) Spas equipped with the optional Jacuzzi Premium audio sys- tem offer enhanced spa enjoyment. These models include a Page 17...
Page 22
high-quality AM/FM/CD stereo receiver with two high-quality speakers for unsurpassed sound quality and long-life. Two speakers located on spa corners (Sec. 8.2, Page 15) are designed for manual exposure and retraction. To expose each speaker for audio playback, simply press download on each enclosure to unlatch it’s “pop-up” mecha- nism, then release.
Page 23
C. Volume Press blue VOL or VOL button to adjust volume to desired listening level. SEL/ SEL/ D. Adjust Treble Press blue SEL button two times to select treble mode. Then press blue or VOL button to adjust treble range from -7 to +7. SEL/ E.
Page 24
G. Adjust Fader SEL/ SEL/ SEL/ Press blue SEL button five SEL/ SEL/ times to select balance mode. Then press blue VOL button to adjust speaker balance as desired. Note: F15 = Front Speakers Only; R15 = Rear Speakers Only. H.
Page 25
Optional Stereo Receiver - Weather Band and Radio Operation A. Select a Weather Band The stereo receiver has a three chan- nel NOAA Weather Radio receiver. NOAA Weather Radio broadcasts National Weather Service warnings, watches, fore-casts, and other hazard information 24-hours a day. Press the grey WB button to change radio to weather radio receiver.
Page 26
C. Program a Station Preset Six numbered green PRESET buttons (1-6) store and recall stations for each radio band. Save a Station Preset: 1. Press grey BAND button to select desired BAND radio band, if necessary. 2. Select radio station by pressing blue + button or - buttons.
Page 27
F. Prescan Stations Scans stations stored in current band. 1. Press grey BAND button to select desired BAND radio band, if necessary. AS/PS 2. Press grey AS/PS button for less than 3-seconds. The radio pauses for 5-seconds at each station. Press grey AS/PS button again to stop scanning when desired station is reached.
Page 28
D. Repeat the Same Track Press green RPT button to continuously repeat same track. Press again to stop repeat. E. Shuffle Play All Tracks Press green SHF button to play all tracks on CD in random order one time. Press again to stop shuffle play.
Page 29
Optional Stereo Receiver Specifications CD Player Signal/noise ratio .......>86 dB Frequency response .
10.0 Automatic Filtration Cycles Your Jacuzzi Premium controls have been designed to provide maximum convenience, as well as economy of operation. By selecting the appropriate filtration mode, you can ensure that your spa will be ready to use anytime with the lowest possible energy consumption.
11.0 Spa Maintenance Proper and regular maintenance of your spa will help it retain its beauty and performance. Your authorized Jacuzzi Premium dealer can supply you with all the information, supplies, and accessory products you will need to accomplish this.
Page 32
To ensure optimum performance, clean and reuse both cartridges once a month. ALWAYS TURN POWER TO SPA OFF BEFORE CLEANING THE FILTER CARTRIDGES! Refer to the filter cleaning/replacement procedure below: TURN POWER TO SPA OFF! filter cover handle handles (Inside Spa View) (Inside Spa View) Skimmer Well Lift upward on filter cover handles to...
(Step E), followed by soaking the filter overnight in a plastic con- tainer filled with a solution of water and a specially formulated filter cleanser available from your Jacuzzi Premium dealer. We also recommend rotating your filter cartridges during each cleaning to maximize life. The average life expectancy of each filter cartridges is approximately two years with proper care, rotation, and water quality maintenance.
Regardless of the cleanser used, use extreme care to assure that no soap residue is left on the surface. This could cause severe sudsing when the spa is refilled. Your Jacuzzi Premium dealer offers a specially formulated surface sealant which aids in cleaning the spa surface and adds a protective coat- ing to enhance the luster of the surface.
1 1.5 Maintaining the Cover Using the Jacuzzi Premium insulating spa cover anytime the spa is not in use will significantly reduce your operating costs, heat-up time and mainte- nance requirements. To prolong the life of the cover, handle it with care and clean it regularly using mild soap and water.
7. Re-install cabinet side panels and cover spa so that no casual moisture can enter into it. Consult your Authorized Jacuzzi Premium Dealer if you have any questions regarding winter use or winterizing. 1 1.8 Restarting Your Spa in Cold Weather...
Some are necessary to compensate for out-of-balance water, some aid in cosmetic water treatment and others simply alter the feel or smell of the water. Your Authorized Jacuzzi Premium dealer can advise you on the use of these additives. CAUTION: Do not use chlorine tablets (Trichlor) in your spa. This chemical can have an extremely corrosive effect on certain mate- rials in the spa.
If condition persists, con- tact your authorized Jacuzzi Premium dealer. There are a number of unique functions designed into your Jacuzzi Premium spa to protect it from damage and/or aid in troubleshooting. Refer to sec- tions 13.3-13.9 below for a listing of all possible error messages and their...
• This error will cause the heater to deactivate. The main pump #1 may also deactivate. • This problem is caused by an interruption in water flow from an excessively dirty filter cartridge, an “air lock” condition at the pump intake, or by a malfunctioning flow switch.
14.0 Troubleshooting Procedures In the event your Jacuzzi® Premium spa is not working the way it should, please first review all the installation and operating instructions in this manual and check the message on the panel display. If you are still not satisfied it is working properly, please follow the appropriate troubleshooting instructions.
Page 41
We build the best spas in the industry. Nonetheless, we are always striving to improve the quality and features of our products. Your input as a Jacuzzi Premium spa owner is a cherished part of this process. If you have any comments or suggestions, or if you wish to be informed on any new prod- ucts for your spa, please write to us.
15.0 J-310 Convertible Circuit Diagram (60Hz) This wiring diagram is used for the J-310 US/Canada 120/240 VAC (60Hz) convertible power model. Page 38...
16.0 J-320/J-330/J-340 Circuit Diagram (60Hz) This wiring diagram is used for all J-320, J-330, J-340 US/Canada 240 VAC (60Hz) dedicated power models. Page 39...
18.0 J-320/J-330/J-340 Circuit Diagram (50Hz) This wiring diagram is used for all J-320, J-330, J-340 Export 230 VAC (50Hz) dedicated power models. D.A.L. 06/13/2002 Page 41...