User Set Mode - Icom IC-F9011B Instruction Manual

■ User set mode

The user set mode is accessed at power ON and allows you
to set seldom-changed settings. You can "customize" the trans-
ceiver operation to suit your preferences and operating style.
When you operate Non-display type, this function is not
available.
Entering the user set mode:
q While pushing and holding [I] and
[II], rotate [VOL] to turn the power
ON.
• Turn power OFF in advance.
• "SET MODE" appears for 1 sec. at
power ON.
w Push and hold [Ω] to enter user
set mode.
[VOL]
[I]/[II]
[Ω]
e Push [Ω] several times to select
the appropriate item.
Then push [∫] or [√] to set the
desired level/condition.
• Available set mode functions are
Backlight, LCD contrast, Beep,
Beep Level, Ringer Level, SQL
Level, AF Min Level, Mic Gain,
VOX Gain*, VOX Delay*, Horn,
Battery Voltage, Signal Moni,
Lone Worker and System info.
* Appears only when the external
VOX unit is connected.
r Push and hold [Ω] again to exit
the user set mode.
User set mode is also available using a programmable key.
Refer to p. 9 [User Set Mode] section for instructions regard-
ing using the key assigned for user set mode.
[User Set Mode] allows for quick item selection. Set "Enable"
for the often used items with the CS-F9010/F9510
. Ask your dealer for details.
sfotware
NOTE: While in the user set mode, [Ω], [∫] and [√] acti-
vate regardless of the assigned key functions.
3
BASIC OPERATION
[Ω]
[∫]/[√]
cloning
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
14