Operation; Water Filtration System (Behind Grille) - Sub-Zero PRO 48 Use & Care Manual

OPERATION

Water Filtration System
The water filtration system of Sub-Zero PRO 48 models
supplies filtered water to the ice maker to produce great-
tasting ice.
When using the water filtration system
IMPORTANT NOTE:
for the first time and after filter replacement, it is necessary
to clear any air from the system and allow the filter to assist
in cleaning the water lines. Discard the first two full con-
tainers of ice.
If the water filtration system will not be utilized, it can be
placed in water filter bypass mode by removing the filter.
The filter is rated for 750 gallons
whichever comes first. When the filter needs to be replaced,
'REPLACE FILTER' will be visible in the external display.
Replacement Sub-Zero water filters can be ordered online
at subzerowolfstore.com. For questions, contact Sub-Zero
customer care at 800-222-7820.
|
8 Sub-Zero Customer Care 800.222.7820
or one year,
(2839 L)
WATER FILTER REPLACEMENT
To access the water filter, pull out on the bottom edge
1
of the grille and rotate upward.
To remove the old filter, rotate counterclockwise one-
2
quarter turn, then pull out. Refer to the illustration below.
It is normal for a small amount of water to drip when
the filter is removed. It should be wiped up with a paper
towel or cloth.
Remove the new filter from packaging and remove the
3
plastic cap.
Insert the new filter into the manifold and turn clockwise.
4
Once the new filter has been installed, the water filter life
5
monitor will automatically reset.
Open grille.
WATER FILTER
Water filter removal.